Designing Systems
This section discusses the tools built in to System Optimiser to create complex loudspeaker system designs effortlessly.
Use the arrangement tool to place loudspeakers in a multitude of shapes and layouts. The template engine is an incredibly powerful way of managing sources from a single controller. Measurement microphones can be placed anywhere within the 3D view. Probes are a smart extension of the measurement microphones that make choosing line array angles stress-free. Link Groups define how line arrays are connected, and allow electronic filters to be applied to correct for distance and splay angle.
- Manipulating Sources
- Source Types
- Source Controllers
- Source Groups
- Source Properties List
- Source Arrangements
- Source Templates
- Presets
- Tuning Filters
- Probes vs Microphones
- Array State and Warnings
- Importing and Exporting Sources
- Rigging Calculations
- Vertical Array Rigging Calculations in System Optimiser
- Note: Your array is valid!
- Note: Use locking pin for element at position X
- Note: When configuring large systems it is recommended to verify with CODA AUDIO’s rigging calculator available at: https://codaaudio.com/rigging
- Note: Safety factor cannot be calculated for this cabinet configuration! Please refer to https://codaaudio.com/rigging for more information.
- Error: Safety factor is less than 10 for top frame
- Error: Safety factor is less than 10 for element at position X
- Error: Negative force on first pickpoint!
- Error: Negative force on second pickpoint!
- Error: Total weight exceeds WLL!
- Error: First Pickpoint load exceeds maximum load, resulting in safety factor below 10!
- Error: Second Pickpoint load exceeds maximum load, resulting in safety factor below 10!
- Error: EXBAR pins have a safety factor below 10, please use a different pickpoint!
- Error: Internal Error: Could not perform rigging calculations! Error:
- Integration with the Template Engine and the Source List
- Vertical Array Rigging Calculations in System Optimiser
- SPL Rendering