Manipulating Sources

Designing, evaluating and optimising loudspeaker sources in System Optimiser is straightforward, thanks to the Source Manager Panel.

To quickly get started adding a source, click one of the first three buttons (each showing a picture of its source type) in the Source Manager’s top bar:

• Add New Horizontal Point Source Array…

• Add New Standard Vertical Array…

• Add New Horizontal Sub Array…

• Source Types
• Source Controllers
  • HPSA Controller
  • SVA Controller
  • HSA Controller
• Source Groups
• Source Properties List
• Source Arrangements
• Source Templates
• Presets
• Tuning Filters
• Frequency Response vs Microphones
• Array State and Warnings
• Importing and Exporting Sources
• Rigging Calculations
  • Vertical Array Rigging Calculations in System Optimiser
    • Note: Your array is valid!
    • Note: Use locking pin for element at position X
    • Note: When configuring large systems it is recommended to verify with CODA AUDIO’s rigging calculator available at: https://codaaudio.com/rigging
    • Note: Safety factor cannot be calculated for this cabinet configuration! Please refer to https://codaaudio.com/rigging for more information.
    • Error: Safety factor is less than 10 for top frame
    • Error: Safety factor is less than 10 for element at position X
    • Error: Negative force on first pickpoint!
    • Error: Negative force on second pickpoint!
    • Error: Total weight exceeds WLL!
    • Error: First Pickpoint load exceeds maximum load, resulting in safety factor below 10!
    • Error: Second Pickpoint load exceeds maximum load, resulting in safety factor below 10!
    • Error: EXBAR pins have a safety factor below 10, please use a different pickpoint!
    • Error: Internal Error: Could not perform rigging calculations! Error:
    • Integration with the Template Engine and the Source List
  • Exporting a Rigging Report as PDF
• Exporting System Geometry