CODA System Optimiser Documentation
Welcome to CODA System Optimiser’s documentation.
Below you can find the table of contents. If you are using the web-based version of this documentation, the table of contents is also shown in the sidebar on the left which you can use to navigate through the documentation.
Before you use System Optimiser, please make yourself familiar with EULA (End-user license agreement) and Disclaimer.
If you are new to System Optimiser, we recommend getting started with the Introduction to System Optimiser. If you want to know what’s new, please refer to the Release Notes.
Table of Contents
- Terms, Conditions & Release Notes
- Introduction to System Optimiser
- Installation
- System Optimiser Quick Start
- Navigating System Optimiser
- Application Settings
- Drawing a Venue
- Designing Systems
- Manipulating Sources
- Source Types
- Source Controllers
- Source Groups
- Source Properties List
- Source Arrangements
- Source Templates
- Presets
- Tuning Filters
- Probes vs Microphones
- Array State and Warnings
- Importing and Exporting Sources
- Rigging Calculations
- Vertical Array Rigging Calculations in System Optimiser
- Note: Your array is valid!
- Note: Use locking pin for element at position X
- Note: When configuring large systems it is recommended to verify with CODA AUDIO’s rigging calculator available at: https://codaaudio.com/rigging
- Note: Safety factor cannot be calculated for this cabinet configuration! Please refer to https://codaaudio.com/rigging for more information.
- Error: Safety factor is less than 10 for top frame
- Error: Safety factor is less than 10 for element at position X
- Error: Negative force on first pickpoint!
- Error: Negative force on second pickpoint!
- Error: Total weight exceeds WLL!
- Error: First Pickpoint load exceeds maximum load, resulting in safety factor below 10!
- Error: Second Pickpoint load exceeds maximum load, resulting in safety factor below 10!
- Error: EXBAR pins have a safety factor below 10, please use a different pickpoint!
- Error: Internal Error: Could not perform rigging calculations! Error:
- Integration with the Template Engine and the Source List
- Vertical Array Rigging Calculations in System Optimiser
- SPL Rendering
- Manipulating Sources
- Additional Information